To assemble your Green Cone, you need the following:
-
Garden Spade
-
Phillips Screwdriver
-
Flathead Screwdriver
Your green cone kit comes with the following hardware
components.
Six Easy Installation Steps:
Place the ribbed side of the hinge on the inside
of the lid. Screw the hinge onto the lid through the pre-drilled holes
using the two male and female studs.
Do not over tighten the studs as you could crack the lid.
The bar across the opening of the
green cone should be removed to allow large food scraps to be emptied
into the cone.
The crossbar can be removed with a small hacksaw or cutters.
(see Frequently Asked Questions)
Attach the twistlock to the outer
Green Cone through the two pre-drilled holes using the two 8x5/8
screws.
Place the lid on top of the Green
outer cone, Part screw the hinge to the Green outer cone using
the three 10x5/8 self tapping screws. When using these screws
pre-drilled holes are not required.
Place the black three holed backplate in place while you tighten the
three screws from the outside of the cone.
Place the black inner cone on top
of the basket.
Place the green outer cone over the black inner,
line up the holes on the green outer with the
"u" shaped slots on the black inner then screw together with the 6
remaining 10x5/8 screws.
Your assembly has finished! Now move onto
Installing the Green Cone.
